These pictures are composites made with Photoshop Elements. The original photo/drawing has been layered on top of the most recent photos of my truck. As you can see, it is a pretty close match. The rail of my truck sits a little high but not too bad. The radiator cowl isn’t far enough forward but I am already worried about losing the cooling ability of the fan now. It sits 4” forward of the original position now. The rear of the cab is a couple inches forward of where it needs to be.  That is close enough. The seat and steering wheel are a little low so those could be corrected when I switch out the seats for a bench seat. The rear fender looks a little low by comparison to the pre-production vehicle but this was raised later in production. I was concerned it wasn’t going to be high enough but I guess it is.